**•How To Make Skyrim Run Better On PS3!•**
Tired of the game-breaking lag with your 20meg Skyrim save files? Here is a guide to help prevent these issues:
1) "Deleting Excess Save Files"
•Go to "Save Data Utility" on the XMB & check how many Skyrim saves আপনি have. If আপনি have আরো then three, মোছা them. আপনি must only have three saves maximum. Also make sure to মোছা any "Auto-Saves."
2) "Freeing Up HDD Space"
•Check how many GBs আপনি have left on your console. Go to "Settings," "System Setting" & then open "System Information." It will প্রদর্শনী আপনি how many GBs আপনি have used and how much মহাকাশ আপনি have left. e.g: 233/320GB. The number on the left will প্রদর্শনী how many GBs আপনি have left. If আপনি don't have much, scroll across the XMB to "Game Data Utility" and মোছা any game's data that আপনি aren't playing anymore/lately. Don't worry, Game data is only "install data," when আপনি decide to play the game again আপনি will just have to install again and your saves will not be affected. If আপনি also want to copy & মোছা game saves, scroll down from "Game Data Utility" and select "Save Data Utility." If আপনি have important saves, don't worry about them. Saves take up hardly any মহাকাশ compared to "Game Data." If আপনি want to free-up as much মহাকাশ as possible, আপনি can plug a USB into the PS3 and copy "non-copy-protected" saves to your thumb drive. That way আপনি can মোছা them off of আপনি system and just copy them back from the USB when আপনি want to play them again. #NOTE# আপনি can copy some "Game Data Utility" as well as "Save Data Utility" if আপনি want to do both. Make sure আপনি have as much মহাকাশ as possible because Skyrim needs quite a bit of HDD মহাকাশ to run properly. My Skyrim Game Data is about 4-5 GBs.
2) Tweaking "Game & Display Settings"
•Sometimes "Graphical Enhancement" settings can interfere with gameplay performance such as frame-rate dips, glitches & lag in massive games like Skyrim. (Don't worry, আপনি will be changing these settings back later!)
#Temporarily Disable The Following:
*Go to "Game Settings" and turn "PS Smoothing" to "Off."
*Scroll down to "Display Settings" and disable/limit all the HDMI Features:
- Super White
- RGB Range to "Limited."
- Cross-Colour Reduction Filter
- Deep Colour Output
3) "Permanently Disabling All In-Game Auto Saves & Testing Performance"
•After you've put all of the ^ *above settings to either "off" অথবা "limited," insert your Skyrim disc and load it up.
Once the game has loaded, go to setting and disable all Auto-Saves listed below (if আপনি haven't already.)
*Save on Wait
*Save on Fast Travel
*Save on Rest
*Save on Character Menu
^ *This will prevent in-game stuttering when your system forces your game to save automatically. It may also decrease লোড হচ্ছে times significantly as well as preventing auto-save files from filling up your load & save menus.
4) "System Restart & Re-Enabling Settings"
•When you've disabled all of the "Auto-Save" options, exit the menu and test how your game is running. Is it good, OK, annoying অথবা terribly unplayable? Most likely it'll either be worse অথবা a even a tiny bit better than it was before আপনি changed the settings. If it's at least a little better, it'll probably still be, well...BAD!
Don't worry! A system restart and another change of settings should fix that right up!
*Quit the game and turn the PS3 off then on again.
*When the PS3 has turned on again, go to back to "Game" and "Display Settings" to re-enable the settings আপনি disabled.
#NOTE# After this আপনি can restart the system again if আপনি want to. আপনি do not have to.
With your re-enabled "Graphic Settings," load up Skyrim again and enjoy the (at least temporary) smoother, consistent frame-rate & a lot less lag! ;) *^_^*
This প্রবন্ধ is by: